Lumion Support Center
Support for unlicensed users => Post here if you can't find your License Key => Topic started by: Simoni on May 05, 2012, 10:24:29 am
-
Is it possible to insert exact numerical info, specifically I have a state texture on a roof, it needs to be exactly parallel to the ridge line, using the heading slider it always jumps to about a degree and a half either side of 90 degrees, never on 90 degrees.
Maybe I have to go back to the SKU model, which would be a shame.
-
http://lumion3d.com/forum/f-a-q/lumion-2-tips-tricks-and-shortcuts/ (http://lumion3d.com/forum/f-a-q/lumion-2-tips-tricks-and-shortcuts/)
Sliders: You can double-click on all sliders in Lumion to manually type in values. Press Shift while adjusting slider values to fine-tune them (more digits after the decimal point will be displayed).
-
thanks Morten.