Topic: Turning off automatical "landing" of objects in Lumion

[st_george]

I am apologizing for a bit strange topic, but I did not know how to formulate it.
Here is the thing:

I would like to add some new parts to my Lumion imported model. The problem is, that these parts will be below current lowest object in Lumion.
I am afraid that after refreshing my new edited model (with these "below" objects included) Lumion object will simply automatically move up due to some Lumion ability to land the most lowest part of the object onto ground.

Is there a way this can be avoided?

To avoid automatically lifting up the Lumion model, and by refreshing the model from the Materials menu, I would get only an update of that model, without lifting?

Thank you.

[Morten]

Hi st_george, are you aware of this function?

Context Menu -> Transformation -> Lock Position -> On

[st_george]

Thank you for the reply Morten.
Forgive me for not being able to check it, but using this Lock Position on "On" will enable that every time I refresh the model from Materials menu with new changes on that model, it will still be on the same position like the previous one, just with additional changes (those new parts/objects I was talking about)?

[Morten]

it will still be on the same position like the previous one, just with additional changes (those new parts/objects I was talking about)?

Yes.