June 09, 2015, 11:41:34 am
Thanks for adding the extra information.
OK, go with what you are currently using. Depends a bit on how far through, and how many more iterations of the model and material edits are required.
Please be aware though of the background, this has been covered in other topics since release of V5.3. Sorry to complicate things a little, but thought it best you are advised and aware.
There were a couple of (major) issues mainly related to the materials system, discovered after the release of V5.0 that were corrected in V5.3. It only affected a few and very small number of users. If you do not end up encountering one of the issues, and most users did not, then of course, it will not matter.
In any case, there are ways to remedy if it happens.
The issues were such that we did advise moving up to v5.3, but left the decision to users. All users that upgraded from V5.0 to V5.3 did so successfully. And, for the few where there was a subsequent materials issue, there was an easy solution to fix.